Some cars arrive at our studio and the whole team stops what they are doing to look. This 2026 Ford Mustang GTD in Oslo Blue was one of them.

The owner wanted the entire car protected before it saw real miles, so our installers wrapped it in full-body XPEL Paint Protection Film and added film to the GTD’s transparent rear suspension cover. It was one of the more demanding installs we have done, and it is a good example of why PPF on a modern performance car is as much about planning as it is about film.

Why the Mustang GTD Matters

The GTD is not a trim level. It is Ford’s street-legal car built on lessons from its Mustang GT3 race program, assembled by Multimatic, the same engineering partner behind the Ford GT. Under the hood is a supercharged 5.2-liter V8 making 815 horsepower. Behind the seats, a window shows off a pushrod rear suspension you would normally only see on a race car.

It also earned its place in history. The GTD became the first American production car to lap the Nürburgring Nordschleife in under seven minutes, a benchmark that had belonged to European supercars.

And it is rare. Based on Ford’s monthly sales reports, only around 650 GTDs were built from the start of production in early 2025 through August 2026, for the whole world. Most Ohio drivers will never see one on the road.

This one is rarer still. The owner chose Oslo Blue, a Porsche color, through Ford’s extended paint program. That makes the car about as distinctive as a GTD gets, and it raises the stakes on the paint. If a factory panel on a one-off color gets chipped, getting a perfect match is difficult, and on a car like this originality is a large part of its value. Protecting the finish from day one is the simplest way to keep it exactly as it left the factory.

The Challenge: PPF on Complex Aero

Most of the GTD’s body is carbon fiber: the fenders, hood, rear deck cover, roof, front splitter and rear diffuser. Nearly every surface is shaped to move air, and that is what makes this car so difficult to wrap.

Deep vents and compound curves

Paint protection film is happiest on smooth, gently curved panels. The GTD has very few of those. Its hood vents, fender openings and sculpted intakes create deep recesses and sharp compound curves where the film has to follow the shape without being stretched too far. Overstretched film thins out, can show distortion, and is more likely to lift over time. Getting full coverage in those areas means deciding exactly where the film should wrap, where it should be relieved, and where a seam will hold best.

Edges that face the wind

On a normal car, a film edge is a cosmetic detail. On a car that generates real downforce, an edge facing the airflow at speed is a place the wind can get under the film. Every leading edge on the GTD, from the splitter to the fender openings, has to be planned so the film is wrapped or terminated where air pushes it down rather than peeling it up.

Wide fenders and clean transitions

The GTD’s widened fenders are some of the most dramatic panels on any Mustang. Their size and shape mean the film has to be laid out carefully so panel transitions line up with the car’s own body lines. The goal is protection that stays invisible, without seams that draw the eye across the bodywork.

Active aero that moves

The GTD uses a hydraulic drag reduction system on its rear wing and flaps in the front underbody that open and close as the car drives. Film near moving aero has to leave proper clearance, so nothing interferes with how those parts work and no edge sits where it can be caught or scuffed by a component in motion.

Full-Body XPEL Paint Protection Film

After a careful wash and prep, our installers covered the painted body in XPEL film. The front end, fenders and lower panels take the brunt of rock chips and road debris on a car this low and wide, and they are now protected along with the rest of the body. XPEL’s self-healing topcoat lets light swirls disappear with heat, which keeps the Oslo Blue looking sharp between washes.

Protecting the Rear Suspension Cover

One of the GTD’s signature details is the GTD-badged transparent cover that shows off the rear suspension from inside the car. A clear panel like that scratches easily, and it is not something you want to replace. We applied paint protection film to it as well, guarding it against scuffs while keeping the view of the suspension clear.

Why Owners Trust ESOTERIC With Cars Like This

A full-body install on a car like the GTD is not something to rush or to hand to a shop that mostly wraps daily drivers. Our team has protected everything from Shelby GT500s to Bronco Raptors, and we plan every install around the shapes of the car in front of us. We take the time to get edges and transitions right, so the protection is there without drawing attention to itself.

You can see more photos of this car on the Ford Mustang GTD project page, and learn more about our paint protection film services.

If you have a special Mustang, or any car with aero that most installers would rather not touch, we would love to see it. Contact our Columbus or Cleveland studio to plan your project.